3.8. Card 7: Requested output times

Refer to Section 4.3 for an example utilizing these parameters.

Table 3.8.1 ITOUT PHITS: other means

Value	Description
(D=1)	Number of times at which outputting of results is requested.

Card 7a: Time listings

Each of the following 2 entries must be listed on a single line, separated by any nonzero number of spaces, and this sequence must be repeated ITOUT times on ITOUT lines.

Table 3.8.2 TMIN PHITS: same name

Value	Description
	Time at which output is requested. These time values are the amount of time elapsed from a reference time, not the lengths of time steps. If TMIN\(>\)0.0, the time corresponds to time elapsed since the beginning of the first time step. If TMIN\(<\)0.0, the time corresponds to the time elapsed since the end of the final irradiation time step (where BEAMPW\(>\)0.0)

Table 3.8.3 TMINU PHITS: same name

Value	Description
	Time units of TMIN expressed as a single character. Acceptable entries are seconds (s), minutes (m), hours (h), days (d), and years (y).

(Note: These times must all be before the end of the calculation as calculated by the sum of the TBIN values.)